A

Single confined seal gasket in wet end provides for ease of ball bearing maintenance without removal of wet end from piping.

B

Fully enclosed impeller with balance holes provides high efficiency and low thrust (no shims or adjustments required).

C

Inducers available for low NPSH applications.

D

Inner magnet is "straddle" mounted between bearings (no overhung load).

E

Silicon Carbide bearings, thrust rings and shaft sleeves provide extremely long life (interchangeable front and rear).

F

Pump and rear casing completely drainable through casing drain plug.

G

Port for thermocouple or RTD to monitor internal temperature.

H

External flush ports for high solids applications.

I

Frame adapter port for mounting leak detection monitor.

J

Anti-contact ribs prevent outer magnet from rubbing on rear casing, in the event ball bearings fail.

K

Large internal magnet radial clearance: 0.060" minimum.

L

Rugged Hastelloy C rear containment shell provides high efficiency and safe positive hermetic sealing.

M

Optional high pressure secondary containment available.

N

Oil-lubricated bearings (easily adaptable to oil mist). Grease-for-life bearings optional.

O

Cooling fins and ports on bearing frame.

P

Neodymium or Samarium Cobalt magnets provide synchronous drive (no slip).

Q

Slotted feet for ease of maintenance.

R

1/2" tap on frame adapter for mounting vibration monitoring equipment.